Do not over-tighten bolts. If changing the mattress base from the upper to the lower position, you must swap over these bolts into position a. Ensure they are secured tightly with the allen key and check regularly that they do not loosen.
Mattress base positioning 1. Mattress base in high position; This is for use when your baby is young and cannot sit up unaided. Mattress base in low position; This is the normal position for an active baby which can sit up unaided. Assembly Instructions - Cot Mode I 16 17 1. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if goods fail to be of acceptable quality and the failure does not amount to a major failure. The Standard Warranty is provided by C.
Bracers 2 pieces Fit the 2 small bracing pieces to the inside of the back and front safety rails and secure to the large cross rails approximately half way across. Designed with stainless steel material, 20 G pitch, 6 mm x 25 mm hex socket button head bolts machine screws.
The terms and conditions of the Standard Warranty are further described below. Any decision to repair or replace a product is to be made by CNP in its absolute discretion. For example an original retailer purchase receipt, bill of sale, invoice, lay-by docket, credit card receipt or similar proof of purchase.
Refurbished parts may be used to repair the product. Replacement of the product or a part does not extend or restart the Warranty Term. Incorrect installation or installation not in accordance with instructions provided; iii. Normal wear and tear; iv. Inadequate or complete lack of maintenance; v.
In New Zealand contact Wainhouse Distribution on or email helpline wainhousedist. Warranty Terms and ConditionsAssembly Instructions - Sofa Seat Mode Removing drop-side panel Assuming that the cot is assembled in cot mode with mattress base in the lower position: Loosen but do not remove the 45mm bolts C in all four corners of the mattress base.
Remove the drop-side panel from the end panels by carefully detaching the drop-side guiding pins D,E,F from the drop- side track. Tighten all bolts on mattress base. Sofa seat is now ready for use. How to care for your bebe care cot Cleaning To ensure the long-lasting use of your cot, wipe down with a damp cloth and use a mild soap solution if necessary. Do not use abrasive cleaners. Always store product in a clean dry place.
Maintenance Check cot regularly to ensure that locking devices and components are secure and working properly. Always check parts regularly for tightness of screws, nuts and other fasteners — tighten or replace if required. To maintain the safety of your cot, seek prompt repairs for bent, torn, worn or broken parts.
Use only those parts and accessories approved by CNP Brands.
В© 2016 - 2018 Business_Blog. All rights reserved | Template by W3layouts